Every truck builder taking on a modern diesel repower eventually runs headfirst into a wiring nightmare. Dropping a common-rail 5.9-liter or 6.7-liter engine into a vintage square-body Chevy or classic Dodge physically fits the frame, but figuring out how to control the fuel injection, sensors, and throttle pedal stumps even seasoned mechanics.

Hitting The Easy Button For A Cummins Swap
Rather than splicing dozens of brittle sensor wires, Greg Alberalla turned to Cody Baldwin at Baldwin’s Performance for a complete standalone harness to manage his single-cab shortbed Dodge project.
The custom loom eliminates the guess work of repinning a factory layout by arriving fully prewired for the exact engine, sensors, and throttle pedal used in the build.
“So if you have a project that you are looking to do, like a common rail swap, I would highly suggest making it super easy on yourself,” Alberalla says.

Relocating The Electronic Control Module
One of the biggest advantages of a custom harness is the ability to relocate the bulky factory computer. On a stock Dodge Ram, the ECM bolts directly to the side of the engine block, cluttering the engine bay and interfering with aftermarket dual CP3 injection pump brackets.
Baldwin’s harness features extended wire lengths and bulkhead connectors, allowing the entire computer to move safely inside the cab. “I’m going to take my factory ECM that’s usually on the side of the engine. We’re going to move it inside the cab with all of the connectors and connections that he is pretty much already pre-done,” Alberalla explains.

Ditching The Factory HVAC Box
Moving the ECM inside the cab of a late-model Dodge Ram presents a serious packaging challenge because the massive factory heater and air conditioning box consumes the entire passenger-side firewall.
Because Alberalla’s shortbed project already deleted the A/C compressor to clean up the front accessory drive, he decided to pull the entire dash and remove the HVAC box entirely to make room for the new electronics and bulkhead connectors.

Cleaning Up The Firewall Wiring
Without the heater box in the way, the custom harness routes cleanly through the firewall alongside the relocated factory Totally Integrated Power Module.
“Basically the TIPM that was here if you want to move the TIPM to the inside of the cab like I did everything is stuffed up inside here,” Alberalla notes, adding that it only requires extending the headlight and starter wires. The result is a Cummins swap with a completely shaved engine bay that hides almost every visible wire.
You might also like
Why SPE Motorsport Invested In Tooling For Its Own CP3 Fuel Pump
SPE Motorsport bought its own tooling to prevent a CP3 Fuel Pump shortage. The Modifuel unit adds upgraded DLC internals and heat treating.